Math Is Fun Forum

  Discussion about math, puzzles, games and fun.   Useful symbols: ÷ × ½ √ ∞ ≠ ≤ ≥ ≈ ⇒ ± ∈ Δ θ ∴ ∑ ∫ • π ƒ -¹ ² ³ °

You are not logged in.

#1 2008-06-10 21:00:45

Kurre
Member
Registered: 2006-07-18
Posts: 280

Sliding blocks

Triangle PQR with area A is given in a plane parallell to the gravitational acceleration g, with the length QR perpendicular to g, and the point P is above QR. Now we let two blocks (considered as points) slide down PQ and PR. This gives the different times t1 respective t2 for each block. If we assume there is no friction, find the minimum of T=t1+t2 and determine the triangle when this occurs.

Offline

#2 2010-02-21 21:20:05

cberry
Member
Registered: 2010-02-19
Posts: 6

Re: Sliding blocks

Assuming no friction, t1=t2 for any position of P (as they would fall at the same rate, due to gravety). Mimimum for t1+t2 then must be where PQ + PR are minimum, eg when P is midway along QR and where area A approaches the limit of 0. (cant be 0 as no longer a triangle).

-or-

Given:  time = distance / acceleration.
We know
1 acceleration (due to gravety) is fixed
2 distance refers to vertical distance only (as no friction)

therefor Time is minimum when vertical distance is minimum. When point P approaches line of QR. And as that happens the shape of the triangle approaches the shape of the line QR

Offline

#3 2010-02-22 00:12:49

JaneFairfax
Member
Registered: 2007-02-23
Posts: 6,868

Re: Sliding blocks

If θ[sub]1[/sub] and θ[sub]2[/sub] are the angles at Q and R respectively and h is the , then

for i = 1, 2 (as can be deduced by application of elementary physics). As the area of the triangle is A, we have

You wanna minimize that? faint

Last edited by JaneFairfax (2010-02-22 02:14:37)

Offline

#4 2010-02-22 00:18:39

JaneFairfax
Member
Registered: 2007-02-23
Posts: 6,868

Re: Sliding blocks

cberry wrote:

Assuming no friction, t1=t2 for any position of P (as they would fall at the same rate, due to gravity).

That is not correct. shame The time taken for an object to fall a vertical distance h is

but if it slides down a frictionless slope inclined at angle θ to the horizontal, the time taken for it to fall the same vertical distance is

(as you can easily work out). So unless θ is 90°, it will take longer to slide down a slope than to fall freely under gravity.

Offline

#5 2010-02-22 18:31:23

cberry
Member
Registered: 2010-02-19
Posts: 6

Re: Sliding blocks

Having looked this up on the net I agree that my suggested solution was way off base.

'Jane', could you have a look at:

"Looking for a solution to a tricky little Hasselhoff problem..."
Posted 2010.02.20

Offline

Board footer

Powered by FluxBB