Math Is Fun Forum

  Discussion about math, puzzles, games and fun.   Useful symbols: ÷ × ½ √ ∞ ≠ ≤ ≥ ≈ ⇒ ± ∈ Δ θ ∴ ∑ ∫ • π ƒ -¹ ² ³ °

You are not logged in.

#1 2016-04-17 00:15:45

ninjaman
Member
Registered: 2013-10-15
Posts: 61

drawing phasor diagram

hello

i have a parallel rlc circuit which seems to be inductive with a 1 amp magnitude(?)
the circuit is explained in a post below about rlc circuits in parallel with complex numbers.
i havent drawn a phasor diagram. the capacitor and resistor currents are really low, in the micro amps with the inductor at 1 amp which is the supply current. so i am guessing that the phasor diagram would be the voltage pointing to 3 oclock and the current pointing toward 12 oclock, the voltage would have a magnitude of 10(volts, the supply voltage) and the current would have a magnitude of 1 amp(the supply current).
would this be correct. i have read a few things on the internet but not to sure if i have grasped the idea.

thanks

simon

Offline

Board footer

Powered by FluxBB