You are not logged in.

- Topics: Active | Unanswered

Pages: **1**

**headstillhurts****Guest**

I know the basics of unit circle but I'm not even remotely aware about where to start with this problem. Any help pointing me in the right direction would be great. Cheers

**bob bundy****Moderator**- Registered: 2010-06-20
- Posts: 6,787

hi headstillhurts

Welcome to the forum.

When AD is a diameter, the angle ABD will always be 90 (or pi/2) so that should get you started.

Bob

You cannot teach a man anything; you can only help him find it within himself..........Galileo Galilei

Offline

**headhurts****Member**- Registered: 2014-05-04
- Posts: 8

bob bundy wrote:

hi headstillhurts

Welcome to the forum.

When AD is a diameter, the angle ABD will always be 90 (or pi/2) so that should get you started.

Bob

Thanks Bob. It took me some time to figure out what the question was even asking. But together with your answer, the whole thing finally clicked.

PS Had problems logging in with my normal account for some reason. So just used a temp account to put that question up earlier.

Offline

Pages: **1**