Discussion about math, puzzles, games and fun. Useful symbols: ÷ × ½ √ ∞ ≠ ≤ ≥ ≈ ⇒ ± ∈ Δ θ ∴ ∑ ∫ π -¹ ² ³ °

You are not logged in.

- Topics: Active | Unanswered

I entered that code. I do not see any picture.

'And fun? If maths is fun, then getting a tooth extraction is fun. A viral infection is fun. Rabies shots are fun.'

'God exists because Mathematics is consistent, and the devil exists because we cannot prove it'

I'm not crazy, my mother had me tested.

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

Just the code? Did you put in a point E?

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

Hi,

I drew up Agnishom's pic, entered your code and got the same for g as you did.

"The good news about computers is that they do what you tell them to do. The bad news is that they do what you tell them to do." - Ted Nelson

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

It is better if you enter IntegralBetween[sqrt(49 - x²), 7, x(E), 0] then he will shade the area.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

It only shaded the left half of the shape and output the area value just for that section.

"The good news about computers is that they do what you tell them to do. The bad news is that they do what you tell them to do." - Ted Nelson

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

Yes but you can see by symmetry that the answer is twice that. I left out the 2 in 2*IntegralBetween[sqrt(49 - x²), 7, x(E), 0] so you can see what geogebra is integrating.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

Yes, I saw the symmetry but wondered if there was a way to shade the whole shape and give the whole area, and so, not knowing what I was doing, I tried reordering components of the expression but always got the same left-half result.

*Last edited by phrontister (2014-03-31 02:46:12)*

"The good news about computers is that they do what you tell them to do. The bad news is that they do what you tell them to do." - Ted Nelson

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

To get both sides shaded you will have to abandon the sector idea and go to circles as she did.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

Is the maths for that fairly simple, or will it need 'integrals' and/or 'functions', neither of which I've ever learnt about? Or something else not taught in high school, perhaps?

I feel I'm getting out of my depth here.

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

Geogebra will do it all for you.

Want to try?

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

Yes. I've already given it a go but wasn't getting anywhere with it (or maybe I was close, but my nose got in the way).

I think I need a hint.

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

Draw the square and use the Circle with radius tool.

Pick point A and click it and enter 7 then do the same with point B.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

I already tried that a while back, but no ideas leapt out at me.

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

It will in just a second. Now use the intersection tool and click on both circles. E and F will be created.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

Done...I hadn't created F before.

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

F will be on the bottom. If it is not then just rename the top intersection point E.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

The orientation is correct. Still no ideas emerging...

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

Okay enter this:

IntegralBetween[sqrt(49 - x²), 7, x(E), 0] and IntegralBetween[sqrt(49 - (x - 7)²), 7, 7, x(E)]

color them any way you like. What do you see?

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

The shape's left and right shaded halves and their respective area values (same for each).

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

Does yours look like this?

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

Yes, exactly.

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

The nice thing is that the equations for the circles are calculated for you. Under conics. With those equations M can now get exact answers. That is what she did.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

You'll have to enlighten me, I think. I've never learnt curve equations and don't understand what they do.

I should really turn in now, though, as it's waaay after midnight. To be continued...(thanks so far )

Offline

**bobbym****bumpkin**- From: Bumpkinland
- Registered: 2009-04-12
- Posts: 109,606

Okay, goodnight and we will continue tomorrow.

**In mathematics, you don't understand things. You just get used to them.****If it ain't broke, fix it until it is.**** Always satisfy the Prime Directive of getting the right answer above all else.**

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,592

Using trig to find that ∠DAE = 30°,

Offline